Heated Degreaser

Heated Degreaser
Product Introduction:
Drawing oil and heavy press lubricant do not release in a cold bath. The Heated Degreaser line from Winsir Decoration Materials Co., Ltd pairs a high-temperature alkali and inorganic-salt powder with an anionic wetting agent, plus a liquid degreaser built on strongly penetrating actives, so high-viscosity and stubborn oil lifts off without attacking the workpiece. Running warm, the emulsifying strength climbs and the stripping power doubles.
Send Inquiry
Description
Technical Parameters

Heat-activated stripping of hard-to-shift oil

 

Drawing oil and heavy press lubricant do not release in a cold bath. The Heated Degreaser line from Winsir Decoration Materials Co., Ltd pairs a high-temperature alkali and inorganic-salt powder with an anionic wetting agent, plus a liquid degreaser built on strongly penetrating actives, so high-viscosity and stubborn oil lifts off without attacking the workpiece. Running warm, the emulsifying strength climbs and the stripping power doubles.

20260624101507
20260624101522

Bath and operating window

 

Made up at about 7% strength, 4-6% component A with 2-4% component B per thousand litres, the bath runs a total alkalinity of 18 to 30. Degreasing temperature sits at 45-80 C, holding the tank near 60-70 C gives the best cut. Immersion takes 8-20 minutes and spray 3 to 5. The concentration is topped up as work consumes it.

Handling and reuse

 

The solution is made up to strength and re-dosed as it weakens, so a bath runs across many parts rather than being dumped. Skimming floating oil off the surface each shift stops parts picking grease back up on the way out. Because the powder is a stable alkali blend, it is dosed by titration, not guesswork.

20260624101538

 

Pack and duty

 

The Heated Degreaser powder comes in 25 kg woven bags and the liquid degreaser in 20 or 25 kg plastic drums, kept sealed in a cool, dry place. It suits the pre-phosphate stage where the next bath only works on a truly clean, oil-free surface.

 

Titrate the bath, do not guess

 

Total alkalinity is checked by titration and held to the duty at hand, so the same bath clears light mill oil or heavy press residue without over-stripping. The powder-and-liquid pair lets a plant fine-tune strength as the load swings shift to shift. A skimming and top-up routine keeps the free-oil load low so the workpiece leaves the bath clean rather than re-contaminated on the way out.

 

Product Specifications

 

Parameter

Specification

Dose

~7% (A 4-6% + B 2-4%)

Total alkalinity (TB)

18-30

Degreasing temperature

45-80 C (best 60-70 C)

Time

8-20 min immersion / 3-5 min spray

Pack

powder 25 kg bag / liquid 20-25 kg drum

 

 

Hot Tags: heated degreaser, China heated degreaser manufacturers, suppliers, factory, Epoxy Intermediate Mortar Coating, Epoxy Micaceous Iron Oxide Intermediate Coat, Epoxy Zinc Rich Paint, Iron based Phosphating Agent, Natural Film forming Agents, Phosphating Agent

Send Inquiry
Professional Technical Team On Standby 24/7
Provide Remote Guidance
or On-Site Service
contact us